Rocketfish RF-ANT50UD Quick Setup Guide - Page 1
Rocketfish RF-ANT50UD Manual
View all Rocketfish RF-ANT50UD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
PACKAGE CONTENTS • Digital outdoor antenna • Power inserter • Coaxial cable • AC Adapter • Installations kits for wall and pole mounting • Quick Setup Guide MOUNTING YOUR ANTENNA Stationary Installation 1 Use the base plate to mark the drilling positions. WARNING: INSTALLATION OF THIS PRODUCT NEAR POWER LINES IS DANGEROUS. FOR YOUR SAFETY, FOLLOW THE INSTALLATION DIRECTIONS. Wall Base plate MOUNTING TOOLS If mounting to a wall, roof, or another surface, you'll need a: • Drill with 5/16" drill bit • Hammer • Phillips screwdriver • Pen or pencil FEATURES • 60-mile range for superior reception, even in difficult locations • Amplifier included to boost weak signals from far away • Designed for outdoor use-resistant to summer and winter elements • Full kit of installation parts included for mounting to exterior walls, roofs, attics, poles, or other surfaces • Works with 4K TVs 2 Use an electric drill with a 5/16" drill bit to drill four holes that are 1.8 in. deep, then clean the holes. Wall 3 Use a hammer to insert the wall anchors (4) into the holes, then attach the base plate to the wall with the large screws (4). Wall Wall Base plate 4 Place the antenna on the base plate, then fasten with the plastic cap screws (4). Antenna Plastic cap screws Wall Flexible Installation 1 Use the pedestal to mark the drilling positions. Wall Pedestal 2 Use an electric drill with a 5/16" drill bit to drill six holes that are 1.8 in. deep, then clean the holes. Wall QUICK SETUP GUIDE RF-ANT50UD, Long-range Outdoor Antenna 3 Use a hammer to insert the wall anchors (6) into the holes, then attach the pedestal to the wall with the large screws (6). Wall Wall Pedestal 5 Attach the base plate to the stand tube with U bolts (2), washers (4), and wing nuts (4). Wing nuts U bolts Stand tube Base plate 4 Place the stand tube into the pedestal, then adjust its position and attach with the screws (2) and hex nuts (2). Stand tube Pedestal 6 Place the antenna on the base plate, then fasten with the plastic cap screws (4). Antenna Plastic cap screws Base plate Before using your new product, please read these instructions to prevent any damage.