Rocketfish RF-RBWS01 User Manual (English) - Page 28

Maintaining your system, Troubleshooting, General troubleshooting

Page 28 highlights

Maintaining your system Use a soft cloth dampened with a weak solution of mild detergent and water. Dry the device immediately afterwards with a clean cloth. Do not use abrasive cloth, thinners, alcohol, or other chemical solvents, because they may damage the finish or remove the panel lettering. Cautions: Do not block the ventilation openings. If the power cord is damaged, it must be repaired by a qualified technician. Troubleshooting Check this information for a possible solution before calling for assistance. General troubleshooting • Every Rocketboost network must contain only one hub device, which helps other Rocketboost devices join the network. • You can turn any Rocketboost wireless sender or wireless sender/receiver into a hub by using the HUB STATUS or HUB ENABLE switch on the back of the device. The network can only have one hub. • The hub device must have power for the audio network to operate. The hub can be in standby (power-saving mode), but must remain plugged in. • The existing hub device will be the device with the green power indicator. • The unobstructed operating range of a Rocketboost network is 150 feet (45 meters). • Each network must contain both a wireless sender device and a wireless receiver device. Do you have both a wireless sender and a wireless receiver device? 28

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35

28
Maintaining your system
Use a soft cloth dampened with a weak solution of mild detergent
and water. Dry the device immediately afterwards with a clean cloth.
Do not use abrasive cloth, thinners, alcohol, or other chemical
solvents, because they may damage the finish or remove the panel
lettering.
Cautions
:
Do not block the ventilation openings.
If the power cord is damaged, it must be repaired by a qualified technician.
Troubleshooting
Check this information for a possible solution before calling for
assistance.
General troubleshooting
Every Rocketboost network must contain only one hub device, which
helps other Rocketboost devices join the network.
You can turn any Rocketboost wireless sender or wireless
sender/receiver into a hub by using the HUB STATUS or HUB ENABLE
switch on the back of the device. The network can only have one hub.
The hub device must have power for the audio network to operate.
The hub can be in standby (power-saving mode), but must remain
plugged in.
The existing hub device will be the device with the green power
indicator.
The unobstructed operating range of a Rocketboost network is 150 feet
(45 meters).
Each network must contain both a wireless sender device and a wireless
receiver device. Do you have both a wireless sender and a wireless
receiver device?