Ryobi AC04148 Operation Manual - Page 1
Ryobi AC04148 Manual
View all Ryobi AC04148 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
Fig. 1 18 VOLT CULTIVATOR TINE SET A AC04142 B WARNING: To reduce the risk of injury, user must read and understand the operator's manual for their product and this instruction sheet. Always wear eye protection with side shields marked to comply with ANSI Z87.1. Ensure compatibility and fit before C using this accessory. Do not use this accessory if a part is damaged or missing. If you are not comfortable performing any of the functions described in these instructions, take your unit to an authorized service center. CALIFORNIA PROPOSITION 65 WARNING: This product and substances that may become airborne from its use may contain chemicals, including lead, known to the State of California to cause cancer, birth defects, or other reproductive harm. Wash hands after handling. D A - Motor head (moteur de tête, motor de cabeza) B - Stud (goujon, vástago) C - Tines (lames, púas) D - Hitch pin (goupille de sûreté, pasador del enganche) Fig. 2 PACKING LIST: 4 in. Tines (2) A Hitch Pins (2) The following instructions apply only to the Ryobi P2700 18 Volt Cultivator. INSTALLING NEW TINES See Figures 1 - 2. WARNING: To prevent accidental starting that could cause serious personal injury, always remove the battery pack from the product when assembling parts. Remove the battery pack. Using pliers, remove the old hitch pins and old tines from the cultivator's motor head. With a clean dry cloth, remove any dirt or debris from around the motor head and studs. Fit the new tines onto the studs of the motor head so that the studs go through the holes of the tines. NOTE: Be sure the flat sides of the studs are aligned with the flat side of the holes of the tines. To secure new tines in place, insert the new hitch pins into the holes located on either side of the studs so that the small rounded section of the hitch pin fits over the stud. B A - Stud (goujon, vástago) B - Hitch pin (goupille de sûreté, pasador del enganche) TECHTRONIC INDUSTRIES NORTH AMERICA, INC. 1428 Pearman Dairy Road, Anderson, SC 29625 USA 1-800-860-4050 • www.ryobitools.com A subsidiary of Techtronic Industries Co., Ltd. • OTC: TTNDY RYOBI is a registered trademark of Ryobi Limited and is used pursuant to a license granted by Ryobi Limited. 990000890 1-8-14 (REV:01)