Ryobi CSB144LZK User Manual 5 - Page 17
Bevel Cutting, Adjusting The Bevel Setting, Warning, Making A Bevel Cut
View all Ryobi CSB144LZK manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
OPERATION BEVEL CUTTING See Figures 19 - 21. Align the line of cut with the inner blade guide notch on the base when making 45° bevel cuts. Make a trial cut in scrap material along a guideline to determine how much you should offset the guideline on the cutting material. Adjust the angle of the cut to any desired setting between zero and 51.5°. Refer to "Adjusting the Bevel Setting" next. NOTE: When making bevel cuts, you may need to re-adjust the laser. (See "Adjusting the Laser.") ADJUSTING THE BEVEL SETTING See Figure 20. Loosen the bevel adjustment knob. Raise the motor housing end of the saw until you reach the desired angle setting on the bevel scale. Tighten the bevel adjustment knob securely. BEVEL ADJUSTMENT KNOB BEVEL SCALE BLADE GUIDE NOTCH MOTOR HOUSING GUIDELINE 4 3 2 45 1 0 1 Fig. 19 WARNING: Attempting a bevel cut without having the bevel adjustment knob securely tightened can result in serious injury. MAKING A BEVEL CUT See Figure 21. Hold the saw firmly with both hands as shown. Rest the front edge of the base on the workpiece. Start the saw and let the blade reach full speed. Guide the saw into the workpiece and make the cut. Release the trigger and allow the blade to come to a complete stop. Lift the saw from the workpiece. 50 45 30 15 2 3 0 45 1 BEVEL SCALE BLADE GUIDE NOTCH BEVEL ADJUSTMENT KNOB Fig. 20 50 45 30 2 3 0 45 1 15 LOWER BLADE GUARD Fig. 21 17