Ryobi DS1100 English Manual - Page 6

OPERATION WARNING: Your sander should never be connected to power supply when you are assembling parts, making adjustments, assembling or replacing sandpaper, cleaning, or when not in use. Disconnecting sander will prevent accidental starting that could cause serious personal injury. APPLICATIONS (Use only for the purposes listed below) s Sanding on wood surfaces. s Removing rust from and sanding steel surfaces. s Polishing and buffing. s Scraping paint or glue from window panes. INSTALLING SANDPAPER See Figure 2. The rubber pad on your sander accepts pressure sensitive adhesive backed sandpaper. Precut triangle shaped sandpaper in assorted grits are available from your local Ryobi dealer. s UNPLUG YOUR SANDER. WARNING: Failure to unplug your sander could result in accidental starting causing possible serious personal injury. ADHESIVE BACKING RUBBER PAD PRESSURE SENSITIVE ADHESIVE BACKED SANDPAPER Fig. 2 s If installing sandpaper for the first time, proceed as follows. If replacing sandpaper, remove old sandpaper by peeling it off rubber pad, then proceed as follows. s Carefully peel paper backing from new sandpaper. s Position sandpaper into place, then carefully press sticky side of sandpaper on rubber pad. WARNING: Never use your detail sander for wet sanding or liquid polishing. Failure to comply can result in electrical shock causing serious injury or worse. WARNING: Before connecting your sander to power supply source, always check to be sure switch is not in ON position. Failure to do so could result in accidental starting of your sander resulting in possible serious injury. WARNING: Do not allow familiarity with your sander to make you careless. Remember that a careless fraction of a second is sufficient to inflict severe injury. WARNING: If any parts are missing do not operate your sander until the missing parts are replaced. Failure to do so could result in possible serious personal injury. Page 6