Ryobi HP41LK English Manual - Page 10

OPERATION WARNING: Do not allow familiarity with products to make you careless. Remember that a careless fraction of a second is sufficient to inflict serious injury. INPUT JACK WARNING: Always wear safety goggles or safety glasses with side shields when operating products. Failure to do so could result in objects being thrown into your eyes, resulting in possible serious injury. RED CHARGE LIGHT CHARGER PLUG WARNING: Do not use any attachments or accessories not recommended by the manufacturer of this product. The use of attachments or accessories not recommended can result in serious personal injury. APPLICATIONS You may use this product for the purposes listed below:  Driving screws with screwdriver bits  Light-duty drilling TO CHARGE See Figure 2. When charging the screwdriver, a red charge light will illuminate on the handle of the screwdriver. This red charge light will go off when the screwdriver is fully charged.  Insert charger plug into input jack making sure it is properly connected.  Charger can be used with normal household current of 120 V, AC only, 60 Hz.  Connect charger to power supply.  After normal usage, a minimum of 9 hours of charging time is required to fully recharge the screwdriver.  Do not place charger in an area of extreme heat or cold. It will work best at normal room temperature.  Remove the product from the charger once it is fully charged and ready for use. WARNING: Battery products are always in operating condition. Therefore, the switch should always be locked when not in use or carrying at your side. CHARGER TO INCREASE TORQUE TORQUE ADJUSTMENT RING ARROW Fig. 2 TO DECREASE TORQUE Fig. 3 adjustable torque clutch This screwdriver is equipped with an adjustable torque clutch for driving different types of screws into different materials. The proper setting depends on the type of material and the size of screw you are using. 10