Ryobi P213 English Manual - Page 15
Installing Chuck, Head Assembly, And, Feed Handles, Installing/changing Worklight Bulb
View all Ryobi P213 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
ASSEMBLY installing chuck, head assembly, and feed handles See Figures 9 - 11. Place the head assembly upside down on a level, flat surface. Position chuck on spindle. Chuck should be fully opened to avoid damaging jaws. Using a piece of scrap wood to protect the chuck, firmly tap the chuck into place using a mallet or hammer. Position the head assembly onto the column with the chuck positioned over the table. Note: This tool is heavy. Get help when needed. feed handle Fig. 11 chuck spindle head assembly scrap wood Slide the head assembly down as far as it will go. Align the table assembly with the base and then tighten the two head set screws with the hex key. Attach the three feed handles by screwing them into the threaded holes in the hub. Installing/changing worklight bulb See Figure 12. The integrated worklight can be used to help illuminate the work area. The worklight requires a 15-watt, 120-volt, candelabra-base bulb (bulb not included). To install, insert the bulb into the worklight receptacle and twist clockwise to secure. Fig. 9 head assembly set screws Fig. 10 15 bulb Fig. 12