Ryobi P213 User Manual 5 - Page 11
Assembly, Adjustments
View all Ryobi P213 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
ASSEMBLY 8. Attach the three feed handles by screwing them into the threaded holes in the hub. 9. Using the pre-drilled holes in the base, mount your drill press securely on a sturdy surface such as a work stand, workbench or counter top. See Figure 9. If your drill press is to be used in a portable application, it is recommended that you fasten it permanently to a mounting board that can be easily clamped to a workbench. WARNING: Do not connect to power supply until assembly is complete. Failure to comply could result in accidental starting and possible serious injury. Once securely mounted on a sturdy surface, check the following: s Check for vibration when the motor is switched ON. Adjust and retighten the mounting hardware as necessary. s Check the table assembly to assure smooth movement up and down the column. s Check to assure that the spindle shaft moves smoothly. MOUNTING BOLTS Fig. 9 ADJUSTMENTS WARNING: Before adjustment, disconnect the drill press from the power source. TABLE ADJUSTMENTS Adjusting the Table Height See Figure 10. To adjust table, hold the table with one hand and loosen the table lock handle. Rotate the table crank handle to lower or raise the table. Clockwise raises the table; counterclockwise lowers it. Position the table in the desired position and retighten the lock handle. TABLE CRANK HANDLE 11 TABLE LOCK HANDLE Fig. 10