Ryobi P360 User Manual - Page 11

MAINTENANCE WARNING: When servicing, use only identical replacement parts. Use of any other parts could create a hazard or cause product damage. GENERAL MAINTENANCE Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage from various types of commercial solvents and may be damaged by their use. Use clean cloths to remove dirt, dust, oil, grease, etc. TROUBLESHOOTING PROBLEM POSSIBLE CAUSE SOLUTION Work-contacting element does not Low staples depress fully - tool does not operate. Work-contacting element is jammed Replenish staples Remove battery and clear debris Tool operates properly, but fasteners do Air pressure is too low not drive fully Depth of drive isn't deep enough Staple is too long for wood hardness Tool operates properly, but fasteners are Air pressure is too high driven too deep Depth of drive is too deep Increase air pressure Adjust depth of drive Use staple length that is appropriate for wood Decrease air pressure Adjust depth of drive Tool jams frequently Tool stops and LEDs flash rapidly Incorrect staples Damaged staples Loose magazine Dirty magazine Battery is low or has no charge Tool is hot Verify that staples are the correct size Replace staples Tighten screws Clean magazine Recharge battery Allow tool to cool Tool has charged battery and LEDs Tool has malfunctioned are slowly flashing or LEDs do not turn off after approximately ten seconds of non-use. Take tool to nearest authorized repair center This product has a Three-year Limited Warranty. For Warranty details go to www.ryobitools.com NOTE: FIGURES (ILLUSTRATIONS) START ON PAGE 12 AFTER FRENCH AND SPANISH LANGUAGE SECTIONS. 11 ­- English