Ryobi P635K Operation Manual - Page 9

OPERATION WARNING: Do not allow familiarity with this product to make you careless. Remember that a careless fraction of a second is sufficient to inflict serious injury. WARNING: Always wear eye protection with side shields marked to comply with ANSI Z87.1. Failure to do so could result in fluids entering your eyes resulting in possible serious injury. To remove:  Depress the latches on both sides of the battery pack to release the battery pack and remove it from the tool. WARNING: Battery tools are always in operating condition. Therefore, switch should always be locked when not in use or carrying at your side. WARNING: Risk of fire or explosion. Spray area must be well­ventilated and away from sparks or flames. WARNING: Do not use any attachments or accessories not recommended by the manufacturer of this product. The use of attachments or accessories not recommended can result in serious personal injury. loading paint into the machine See Figure 8, page 16. Remove and discard any skin that has formed on top of the paint or stain, then thoroughly mix the material in its original container before beginning. APPLICATIONS You may use this product for the purpose listed below:  Interior and exterior painting and staining of decks, outdoor furniture, fences, and walls This product will accept Ryobi One+ 18 V lithium-ion battery packs and Ryobi One+ 18 V nickel-cadmium battery packs. For complete charging instructions, refer to the Operator's Manuals for your Ryobi One+ battery pack and charger models. BATTERY PROTECTION FEATURES Ryobi lithium-ion batteries are designed with features that protect the lithium-ion cells and maximize battery life. If the tool stops during use, release the trigger to reset and resume operation. If the tool still does not work, the battery needs to be recharged. TO INSTALL/remove BATTERY PACK See Figure 7, page 16. NOTE: Older containers of stain and paint may need to be strained before use. The backpack tank will hold up to 1.5 gallons.  Remove battery pack, if installed.  Open the lid of the backpack tank.  Carefully pour up to 1.5 gallons of paint or stain into the tank.  Close the tank lid and press down firmly. Make sure the intake tube and filter go all the way to the bottom of the tank and the recirculating hose is also fully seated in the tank. MOTOR SWITCH See Figure 9, page 16.  To paint, set the switch in the forward position. In forward, the machine moves the paint from the tank into the sprayer or roller.  With the switch set in the reverse position, the machine pulls the excess paint back through the paint tubes and into the paint tank, leaving less paint to clean up. WARNING: Always remove battery pack from your tool when you are assembling parts, making adjustments, cleaning, or when not in use. Removing battery pack will prevent accidental starting that could cause serious personal injury. To install:  In the center position, the unit is off. ADJUSTING HARNESS and waist STRAPS Straps should be adjusted to a comfortable position before starting the unit. To adjust harness strap assembly: There are three possible height adjustment positions that can be used to easily adjust harness.  Place the battery pack in the tool. Align the raised rib on  Slip top buckle of harness from adjustment slot and the battery pack with groove in the battery port. position to desired height location.  Make sure the latches on each side of the battery pack snap in place and that the battery pack is secured in the tool before beginning operation.  Tighten (pull down on strap) or loosen (lift up on tab of strap buckle) each harness strap as needed, until each is adjusted to a comfortable operating position. 9 - English