Ryobi P750 Manual 1 - Page 7
Operation - hybrid transfer pump
View all Ryobi P750 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
OPERATION WARNING: Do not allow familiarity with products to make you careless. Remember that a careless fraction of a second is sufficient to inflict serious injury. WARNING: Keep water discharge pointed away from all electrical devices to reduce the risk of electrocution or electric shock. WARNING: Ensure all hose connections are secure before using the transfer pump Spilled water and leaks can result in a slippery surface and create a slip and fall hazard. WARNING: Do not use any attachments or accessories not recommended by the manufacturer of this product. The use of attachments or accessories not recommended can result in serious personal injury. WARNING: Always remove battery pack or unplug power cord from your product when you are assembling parts, making adjustments, cleaning, or when not in use. Removing battery pack or unplugging power cord will prevent accidental starting that could cause serious personal injury. APPLICATIONS You may use this tool for the purpose listed below: Drain or remove water from flooded areas, clogged sinks, water basins, etc. NOTICE: This product is designed to be powered by either a RYOBI™ One+™ 18V battery pack (DC mode) or by electric power (AC mode). Either power source can be used by installing an approved battery pack or power cord into the product as described in this manual. INSTALLING/REMOVING BATTERY PACK See Figures 4 and 6, page 11. Set the ON/OFF switch to the OFF position. Press outward on the tab to open the battery cover latch. Insert the battery pack into the battery port. Make sure the latches on each side of the battery pack snap into place and the battery pack is secured before beginning operation. Close the battery cover and press until it snaps shut. For complete charging instructions, see the operator's manuals for your battery pack and charger. INSTALLING/REMOVING POWER CORD See Figures 5 and 6, page 11. WARNING: Do not route cord under carpets, rugs, runners, furniture, or appliances and always route cord away from traffic areas to prevent a tripping hazard. Press outward on the tab to open the battery cover latch. Insert the female end of the power supply cord into the product as shown until it clicks into place. Connect the male end of the power cord to the power source. Make sure the power cord is secured before beginning operation. To remove the power cord, unplug the cord from the power source. Press the release button on the top of the female end of the power supply cord and remove from the tool. STARTING/STOPPING THE TRANSFER PUMP See Figure 6, page 11. Add two drops of oil into the water inlet before and after each use. Add water to the water inlet side of the pump to prime the impeller. Connect the product to an AC or DC power supply. WARNING: Hybrid tools are always in operating condition. Therefore, unit should always be in the OFF position, with the battery pack removed and power cord disconnected, when not in use. Do not leave pump on while unattended. Failure to follow these instructions could result in serious personal injury. 7 - English