Ryobi P782 Operation Manual - Page 9

OPERATION POWER BUTTON (HIGH/LOW/OFF) See Figure 9, page 11 The work light will be in the OFF position until the power button is pressed.  Connect the product to an AC or DC power supply.  Press and release the button once to activate HIGH mode.  Press and release the button again for LOW mode.  Press and release the button a third time to turn the work light OFF. NOTE: This light is equipped with a low voltage indicator. If the light flashes 3 times while a battery pack is installed, this indicates a low charge condition. Four additional flashes indicate that shutdown will follow quickly. Install a charged battery pack and resume operation. WARNING: Hybrid tools are always in operating condition. Therefore, unit should always be in the OFF status, with the battery pack removed and power cord disconnected, when not in use. Do not leave light on while unattended. Failure to follow these instructions could result in serious personal injury. WARNING: Keep work light away from combustible materials. If wrapped or in contact with fabrics, the work light lens can produce sufficient heat to melt some fabrics. To avoid serious personal injury, never allow the work light lens to come in contact with anything. ADJUSTABLE HEAD See Figure 10, page 11. CAUTION: Do not place hands or fingers between adjustable head and frame when positioning work light to avoid pinching your fingers or hands. The adjustable head can be set in a variety of positions. Adjust the head as desired. MAINTENANCE WARNING: When servicing, use only identical replacement parts. Use of any other parts may create a hazard or cause product damage. GENERAL MAINTENANCE Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage from various types of commercial solvents and may be damaged by their use. NOTICE: The LEDs cannot be replaced. Any attempt to replace the LEDs may damage the light. STORAGE Store indoors in a dry, locked-up place, out of the reach of children, with the battery pack removed and power cord disconnected. Keep away from corrosive agents such as garden chemicals and de-icing salts. NOTE: ILLUSTRATIONS BEGIN ON PAGE 10 FOLLOWING FRENCH AND SPANISH LANGUAGE SECTIONS. 9 - English