Ryobi PCL631B Operation Manual - Page 6

OPERATION INSTALLING/REMOVING BATTERY PACK See Figure 1, page 8  Insert the battery pack into the product as shown.  Make sure the latches on each side of the battery pack snap into place and the battery pack is secured before beginning operation.  Depress the latches to remove the battery pack. WARNING: Keep work light away from combustible materials. If wrapped or in contact with fabrics, the work light lens can produce sufficient heat to melt some fabrics. To avoid serious personal injury, never allow the work light lens to come in contact with anything. WARNING: Always remove battery pack or unplug extension cord from your product when you are assembling parts, making adjustments, cleaning, or when not in use. Removing battery pack or unplugging extension cord will prevent accidental starting that could cause serious personal injury. INSTALLING/REMOVING POWER CORD See Figure 2, page 8. WARNING: Do not route cord under carpets, rugs, runners, furniture, or appliances and always route cord away from traffic areas to prevent a tripping hazard.  Insert the female end of the power cord into the product as shown.  Connect the male end of the power cord to the power source. Make sure the power cord is seated securely before beginning operation.  To remove the power cord, disconnect the cord from the power source and then from the rear of the light. POWER BUTTON (HIGH/MEDIUM/LOW/OFF) See Figure 3, page 8. The work light will be in the OFF position until the power button is pressed.  Connect the product to the battery pack.  Press and release the button to cycle between HIGH, MEDIUM, LOW, and OFF.  Press and hold the button for two seconds while ON (in any mode) and the light will shut off.  Press and hold the button for two seconds while OFF allows the light to go into low mode. NOTE: This light is equipped with a low voltage indicator. If the light flashes 3 times while a battery pack is installed, this indicates a low charge condition. Install a charged battery pack and resume operation. OPERATING THE PANEL LIGHT See Figure 4, page 9. WARNING: Hybrid tools are always in operating condition. Therefore, unit should always be in the OFF status, with the battery pack removed and power cord disconnected, when not in use. Do not leave light on while unattended. Failure to follow these instructions could result in serious personal injury.  Install battery pack or connect product to an AC power supply.  Press the power button to turn panel light on and off.  Place the light's adjustable panels in the positions needed to direct light as desired. WARNING: Keep panel light away from combustible materials. If wrapped or in contact with fabrics, the panel light lens can produce sufficient heat to melt some fabrics. To avoid serious personal injury, never allow the panel light lens to come in contact with anything. ADJUSTABLE HEAD See Figure 5, page 9. CAUTION: Do not place hands or fingers between adjustable head and frame when positioning panel light to avoid pinching your fingers or hands. In addition to adjusting the individual LED panels of the light, the adjustable head can also be set in a variety of positions. To adjust positions:  Adjust head to desired position.  The hinge of the light head has adequate tension to hold the adjustable head in position. Over time, the hinge could lose tension causing the head to droop or sag. If the light head stops holding its position, tighten the exposed hex bolts as needed. 6 - English