Ryobi PSBCS01B Operation Manual - Page 11

ADJUSTMENTS POSITIVE 0° BEVEL STOP See Figure 20, page 16. The saw has a positive 0° bevel stop that has been factory adjusted to assure 0° angle of the saw blade when making 0° cuts. However, misalignment can occur during shipping. To check positive 0° bevel stop: „ Remove the battery pack. „ Place the saw in an upside down position on a workbench. „ Move the lower blade guard out of the way so that the saw blade is exposed. „ Check the squareness of the saw blade to the base of the saw using a combination square. To adjust positive 0° bevel stop: „ Remove the battery pack. „ Rotate the bevel lock lever counterclockwise to release. „ Insert a 2.5 mm hex key (not included) through the screw hole in the saw base. „ Turn adjustment screw and adjust base until it is square with the saw blade. „ Securely lock the bevel lock lever. WARNING: Attempting a bevel cut without having the bevel lock lever securely locked in place can result in serious injury. 11 - English