Samsung DV435GTGJRA/A1 Trouble Shooting Guide User Manual Ver.1.0 (English, Fr - Page 7
Warning
View all Samsung DV435GTGJRA/A1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
TROUBLE SHOOTING WARNING To avoid risk of electrical shock, personal injury or death; disconnect power to dryer before servicing, unless testing requires power. No Problem 8 The igniter does not glow 9 Igniter glows - No gas ignition The gas is ignited 10 but the flame goes out Improper drying 11 clothes wrinkled Rough texture long dry time 12 Noisy and/Or Vibration What To Do If the igniter does not heat up, remove power and using an ohmmeter, check the following: • Open flame sensor • Open igniter • Shorted booster coil • Open wiring • Bad motor switch ( Neutral supply) • No power from control ( L1 supply) If the igniter heats up but the main burner flame is not ignited, remove power and using an ohmmeter, check the following: • Open secondary coil • Open holding coil • Open wire harness • Stuck flame sensor (Stuck closed) If a normal ignition takes place and after a short while the flame goes out, check for the following: • Radiant sensor contacts opening prematurely. • Weak gas valve coil may open when stressed by higher Temps. • Weak Hi-Limit • Poor venting • Bad drum seals • Lint filter is not clean. • Restriction in exhaust. • Outside exhaust hood damper door stuck closed. • Exhaust too long, too many elbows, flex ductwork installed. • Poor intake air available for the dryer. • Incorrect tumbler speed. Tumbler belt slipping. • Blower impeller bound; check for foreign material in blower area. • Customer overloading dryer. • Check clothing labels for fabric content and cycle selected. • Clothes too wet due to insufficient spin out by washer. • Thumping Check for loose tumbler baffle, rear tumbler roller(s) worn or misaligned, out-of-round tumbler or high weld seam on tumbler. • Ticking Check for loose wire harness or object caught in blower wheel area. • Scraping Check for front or rear bulkhead felt seal out of position or worn tumbler front bearings. • Roaring Check for blower wheel rubbing on blower housing or bad motor bearings. • Popping or squealing sound. Check for a sticky or frayed belt. 7 Technical_information-02835E_EN.indd 7 2012-05-16 �� 5:10:02