Samsung ML-3561N User Manual (ENGLISH) - Page 28
PCL Menu, OPC Cleaning, Fuser Cleaning, Life Remaining, Pitch, Point Size - fuser unit
UPC - 635753624014
View all Samsung ML-3561N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
Item Explanation Auto Continue Values: Off, On* This item determines whether or not the printer continues printing when it detects the paper unmatched to your paper setting. • Off: If the paper mismatch occurs, the message will remain on the display and the printer will remain off-line until you insert the correct paper. • On: If the paper mismatch occurs, an error message will display. The printer will go offline for 30 seconds and automatically clear the message and continue printing. Values: Off*, On JAM Recovery This item determines how the printer behaves when a paper jam occurs. • Off: The printer does not reprint pages. Printing performance might be increased with this setting. • On: The printer automatically reprints pages after you clear the paper jam. Altitude Adj. Values: Low*, High You can optimize print quality depending on the air pressure, such as in a high ground. Auto CR Values: LF*, LF+CR This item allows you to append the required carriage return to each line feed. Refer to the following samples: AA BB LF AA BB LF+CR Values: 0 ~ 1800 sec *15 sec Job Time Out You can set the time length the printer waits before printing the last page of a print job that does not end with a command to print the page. When a job time-out occurs, the printer prints the page in the print buffer. Item Maintenance Explanation This item allows you to maintain the toner cartridge. • OPC Cleaning: Cleans the OPC drum of the cartridge and produces a cleaning sheet with toner debris on it. • Fuser Cleaning: Cleans the fuser unit inside of the printer and produces a cleaning sheet with toner debris on it. • Life Remaining: This item allows you to check how much toner are left in the cartridge. PCL Menu This menu sets the PCL emulation configuration. You can set the font type, symbol type, lines per page, and point size. (*: the default setting) Item Explanation Typeface Values: PCL1* ~ PCL68 You can select the standard font to be used in PCL emulation. • PCL1~PCL7's interval between letters is fixed, and PCL8~PCL45's interval is proportional to the font type and point size. You can adjust the font size of PCL1~PCL7 using the Pitch item, and PCL8~PCL45 can do using Point Size item. • PCL46~PCL54's interval and point size are fixed. Symbol Values: ROMAN8 ~ PCCYRILLIC *PC8 This item selects the symbol to be used in PCL emulation. The symbol is the group of numbers, marks, and special signs being used when printing letters. Lines Values: 5 ~ 128 *60 (Letter), 64 (A4) This item allows you to set vertical spacing from 5 to 128 lines for the default paper size. The lines may differ according to the paper size and printing orientation. 3.7 Using the Control Panel