Samsung TXN3235F User Manual (user Manual) (ver.1.0) (English) - Page 28

Storing Channels in Memory Automatic Method

Get Samsung TXN3235F PDF manuals and user guides View all Samsung TXN3235F manuals
Add to My Manuals
Save this manual to your list of manuals

Page 28 highlights

OPERATION Storing Channels in Memory (Automatic Method) 1 First, select the correct signal source (ANT, STD, HRC, IRC). See steps 1~4 on previous page. Press the MENU button, then press the CH w button twice to select "Channel." Press the VOL + button to access the Channel submenu. 2 Press the CH w button to select "Auto program". w 3 Press the VOL + button. The TV will begin memorizing all of the available channels. 4 After all the available channels are stored, the Auto program menu reappears. Press the MENU button twice to exit. Note: Channel auto program does not function when the V-chip is active. The TV automatically cycles through all of the available channels and stores them in memory. This takes about one to two minutes. Press MENU at any time to interrupt the memorization process and return to the Channel menu. 3.6 CHAPTER THREE: TV OPERATION

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
3
.6
C
HAPTER
T
HREE
: TV O
PERATION
O
PERATION
3
Press the
VOL +
button.
The TV will begin
memorizing all of the
available channels.
4
After all the available
channels are stored, the
Auto program menu reap-
pears. Press the
MENU
button twice to exit.
Storing Channels in Memory (Automatic Method)
▼
The TV automatically cycles
through all of the available channels
and stores them in memory. This
takes about one to two minutes.
Press
MENU
at any time to interrupt
the memorization process and return
to the Channel menu.
2
Press the
CH
▼
button to
select “Auto program”.
1
First, select the correct
signal source (ANT, STD,
HRC, IRC). See steps 1~4
on previous page.
Press the
MENU
button,
then press the
CH
▼
but-
ton
twice to select
“Channel.”
Press the
VOL +
button to
access the Channel sub-
menu.
Note: Channel auto program does not function when the
V-chip is active.