Samsung WA45N3050AW/A4 User Manual - Page 27
STEP 5, Test run, RINSE + SPIN, POWER, Cycle Selector, START/PAUSE, Connecting the water supply hose
View all Samsung WA45N3050AW/A4 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
Installation STEP 5 Powering your washer Plug the power cord into a 3-prong, well grounded 120 volt 60 Hz approved electrical outlet protected by a 15-amp fuse or comparable circuit breaker. Your washer is grounded through the third prong of the power cord when plugged into a three-prong grounded electrical outlet. Test run Make sure that you install your washer correctly by running the RINSE + SPIN after the installation is complete. STEP 6 Running a test cycle Run a test cycle as follows to check if your washer is properly installed. 1. Load about 6 pounds of laundry into the tub. 2. Press POWER to turn on your washer. 3. Select RINSE + SPIN by turning the Cycle Selector. 4. Press START/PAUSE to start the test cycle. 5. The washer should not rock or vibrate excessively when water is supplied or when washing or spinning, and should drain well during the spin cycle. NOTE If water leaks while water is being supplied or drained, check the water connections. Refer to the "STEP 2 Connecting the water supply hose" section on page 21 for instructions. NOTE If the washer rocks and vibrates excessively, level your washer again. Refer to the "STEP 4 Leveling your washer" section on page 25 for instructions. WA3100M_DC68-03850A-05_EN.indd 27 English 27 2019-02-14 6:21:50