Samsung WF331ANR/XAA User Manual (user Manual) (ver.1.0) (English) - Page 15
Installing Your Washer
UPC - 036725560772
View all Samsung WF331ANR/XAA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
01 SETTING UP INSTALLING YOUR WASHER STEP 1 Selecting a location Before you install the washer, make sure the location: • Has a hard, level surface without carpeting or flooring that may obstruct ventilation. • Is away from direct sunlight. • Has adequate ventilation. • Will not be freezing (below 32 ˚F or 0 ˚C). • Is away from heat sources such as oil or gas. • Has enough space so that the washer doesn't stand on its power cord. STEP 2 Removing the shipping bolts Before using your washer, you must remove the four shipping bolts from the back of the unit. 1. Loosen all the bolts with the supplied wrench. 2. Slide the bolt and spacer up and remove the bolt with the spacer through the hole in the rear wall of your washer. Repeat for each bolt. 3. Fill the holes with the supplied bolt hole covers. 4. Keep the shipping bolts and spacers for future use. STEP 3 Installing your washer 1. Place the drain hose in the drain facility. Be sure an airtight connection is NOT made between the drain hose and the standpipe. The standpipe must be at least 18in.(46 cm) high. Caution must always be exercised to avoid collapsing or damaging the drain hose. For best results, the drain hose should not be restricted in any way - by elbows, couplings, or excessive lengths. 96" Max For situations where the drain hose 18" Min cannot be conveniently elevated to at least 18in.(46 cm), the drain hose must be supported. Laundry tub Hose Guide Stand pipe Hose retainer Tie strap 96" Max 18" Min 2. Before connect the inlet hoses to water faucets, check to ensure a washer is inside coupling. Coupling Rubber Washer setting up your new washing machine _15 WF350AN-02833A-03_EN.indd Sec4:15 2010-12-09 5:14:58