Samsung WF45R6300AW/US User Manual - Page 55
Self Clean
View all Samsung WF45R6300AW/US manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 55 highlights
Problem Action Fills with the wrong temperature water. • Fully open both taps. • Make sure the temperature selection is correct. • Make sure the hoses are connected to the correct taps. Flush water lines. • Make sure your water heater is set to supply hot water with a minimum temperature of 120 °F (49 °C) at the tap. Also, check the water heater capacity and recovery rate. • Disconnect the hoses and clean the mesh filters. The mesh filters may be clogged. • While the washer fills, the water temperature may change as the automatic temperature control feature checks incoming water temperature. This is normal. • While the washer fills, you may notice just hot and/or just cold water going through the dispenser when cold or warm temperatures are selected. This is a normal function of the automatic temperature control feature as the washer determines the water temperature. • Use the High or Extra High spin speed. • Use high efficiency (HE) detergent to reduce oversudsing. The load is wet at the • The load is too small. Small loads (one or two items) may end of a cycle. become unbalanced and not spin completely. • Make sure the drain hose is not kinked or clogged. Leaks water. • Make sure the door is properly closed. • Make sure all hose connections are tight. • Make sure the end of the drain hose is correctly inserted and secured to the drain system. • Avoid overloading. • Use high efficiency (HE) detergent to prevent oversudsing. Has odors. • Excessive suds collect in recesses and can cause foul odors. • Run cleansing cycles to sanitize periodically. • Clean the door seal (diaphragm). • Dry the washer interior after a cycle has finished. After a cycle, washer is not off and/or the door does not open. • If the Remaining Laundry Notification is on, press Power to turn the power off, and then remove the items. • If the SELF CLEAN indicator is on, remove all items from the drum, and then run the SELF CLEAN cycle. If a problem persists, contact a local Samsung service center. Troubleshooting English 55