Sanyo AWM-660 Instruction Manual - Page 11
Listening To The Radio - manual
View all Sanyo AWM-660 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
LISTENING TO THE RADIO FREQUENCY UP/DOWN TUNING Automatic tuning TO PRESET STATIONS (Remote control only) Up to 20 FM and 12 AM stations can be preset. 2 1 1 2 3 2 456 789 0 1 FM MODE TUNER /REPEAT 1. Press [FUNCTION] (or [TUNER/BAND] on the remote control) to select AM or FM. The radio frequency appears. 3 2,4 1 2 3 456 789 0 FM MODE TUNER /REPEAT /BAND 1. Tune in the station to be preset as described above. or TUNER /BAND 2. Press [TUNING +] or [TUNING -] for at least 1 second to tune in a station. The unit will scan up or down the band and receive the next receivable station. Press the button again to continue. • The [TUNING +] or [TUNING -] on the remote control can also be used. - TUNING + 2. Press [MEMORY]. 3. Press [TU PRESET] to select the channel number to be preset. Manual tuning 1. Press [FUNCTION] to select AM or FM. 2. Press [TUNING +] or [TUNING -] continuously until you are close to the desired frequency, then press it briefly until the desired frequency is displayed. Each time the button is pressed, the frequency changes in 200 kHz steps for FM and 10 kHz steps for AM. • The number buttons on the remote control can also be used. Two buttons must always be pressed. Example: To select No. 9, press [0], then [9]. To select No. 10, press [1], then [0]. 4. Press [MEMORY]. • If using the number buttons on the remote control, this step is not necessary. • In this example, "103.1 MHz" FM station is preset on FM channel number 9. Need help? Call 1-800-813-3435 NOTE: If the next step is not taken within 10 seconds while performing steps 2 - 4. "PROG." disappears and the preset operation is cancelled. Press [MEMORY] to continue. 5. Repeat the steps above to add more preset stations. • When presetting a new station, the previously preset station on the same program number of the same band is cleared. • The preset stations will be retained in the memory even if the unit is turned off. • If the memory contents are lost due to a power failure or other condition, program the stations again. AWM-660/US Eng page 11 -E10- 4/16/04, 5:40 PM