Sanyo CLT2054 Owners Manual - Page 6
Installing Batteries in the Remote Control, Connecting Cable service, RF antenna, or Satellite
View all Sanyo CLT2054 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Getting Started QuickTips ■ The TV will automatically select the correct Antenna mode for the type of RF signal you connect. ■ TV will switch off automatically after 15 minutes if there is no signal reception (cable out or station not broadcasting). Exception-When the Video mode is selected, the TV will not automatically switch off when signal reception has stopped for 15 minutes. ■ If you move the TV to a new location, press the RESET key twice after connecting the signal and turning on the TV. Need help? Visit our Web site at www.sanyoctv.com or Call 1-800-877-5032 Installing Batteries in the Remote Control Use 2 "AAA" batteries (Not supplied). Be sure batteries are installed correctly. Note: Do not mix old batteries with new ones or mix different types of batteries together. Connecting Cable service, RF antenna, or Satellite Receiver to the TV AV2 AV1 S-VIDEO V V L (MONO) R L (MONO) R AV3 Y L Pb R Pr CABLE SATELLITE RECEIVER RF ANTENNA A/V OUT (480i) ANT LOOP OUT OUTPUT SELECTION YPbPr RGB ANT IN DIGITAL AUDIO OUT (OPTICAL) VIDEO S-VIDEO L OUT AUDIO R DIGITAL COMPONENT OUT AUDIO OUT (1080i/720p/480p) Y COAXIAL PB AUTHORIZED SERVICE ONLY RGB OUT PR (1080i/720/480p) TUNER VHF UHF CATV DC IN POWER (DC IN 19V) IN R-AUDIO-L VIDEO OUT R-AUDIO-L VIDEO IN RF CHANNEL 34 FROM ANT. VHF/UHF TO TV OUT VCR TV BACK TV-75 OHM CONNECTOR Note: If you do not have a VCR, connect signal directly to the TV 75 ohm jack. Operational Tip for No Signal Connection: If the TV is used as a monitor only, with a DVD player or some other type of external equipment, and no cable or antenna signal is available, the following setup is necessary: Your TV is designed to automatically search for available channels. Therefore, the initial start up requires that you press the MENU key, enabling the TV to automatically go through the channel search process before you can operate the TV. After the initial channel search is completed, you must press the MENU key again to complete the channel search process, it will take a few minutes for the TV to complete searching. After channel search is complete (2 searches), you can press the INPUT key on the remote control to use the TV as a monitor. CATV FRANCHISE NOTE: Cable companies, like public utilities, are franchised by local government authorities. To receive cable programs, even with equipment which is capable of receiving cable channels, the consumer must subscribe to the cable company's service. 6 Installing Batteries / Signal Connection: Cable, Antenna, or Satellite Receiver