Sanyo DP52449 Owners Manual - Page 5
Stand Removal And Wall Mouting, Getting Started - remote
View all Sanyo DP52449 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
STAND REMOVAL AND WALL MOUTING (OPTIONAL) Tools Needed: Phillips screwdriver No. 3 IMPORTANT NOTE: Place HDTV face down on a padded or cushioned surface to protect the screen and finish. Wall mounting of the HDTV must be performed by a skilled person. DP42849 DP46849 DP52449 1 Remove the four (4) screws securing the foot stand. CAUTION: Hold the stand firmly as you remove the last screw. 2 Use the screws you removed when detaching the stand to secure the HDTV to a wall mounting kit (kit not included.) VESA standard interface: 400 x 400 Mounting screws measurements: M6 (6mm) Diameter, Length-16mm (maximum) 1 Remove the four (4) screws securing the foot stand. CAUTION: Hold the stand firmly as you remove the last screw. 2 Use the screws you removed when detaching the stand to secure the HDTV to a wall mounting kit (kit not included.) VESA standard interface: 400 x 400 Mounting screws measurements: M6 (6mm) Diameter, Length-16mm (max.) GETTING STARTED Install batteries in the remote control ( 2 "AAA", not included) PRECAUTIONS To ensure safe operation, please observe the following precautions: • Replace both batteries at the same time. Do not use a new battery with a used battery. • There's a risk of explosion if a battery is replaced by an incorrect type. • Do not expose the Remote Control unit to moisture or heat. • Be sure to match the "+" and "-" signs on the batteries with marks inside the remote control. ANTENNA CONNECTION FOR OFF-AIR SIGNALS OR CABLE ANTENNA CABLE ANALOG / DIGITAL ANTENNA IN Note: The tuner in this HDTV can receive digital and analog off air signals from an antenna. It can also receive analog or ClearQAM cable channels from a direct Cable TV connection. Need help? www.sanyoctv.com 1-800-877-5032 5