Sanyo EF30NL Owners Manual - Page 45

APPENDIX LAMP REPLACEMENT CAUTION For continued safety, replace with a lamp assembly of same type. Allow a projector to cool for at least 45 minutes before you open Lamp Cover. Inside of a projector can become very hot. C4, CAUTION Do not drop a lamp assembly or touch a glass bulb! Glass can shatter and may cause injury. Follow these steps to replace lamp assembly. 1 Check number of lamp to be replaced on Lamp Status Display. 2 Turn off a projector and disconnect AC Power Cord. Allow a projector to cool for at least 45 minutes. SCREWS 3 Loosen 3 screws on Lamp Cover and remove Lamp Cover. (See right figure.) 4 Loosen 2 screws and pull out Lamp Assembly to be replaced by grasping handle. 5 Replace Lamp Assembly with a new one and tighten 2 screws. Make sure that Lamp Assembly is set properly 6 Replace Lamp Cover and tighten 3 screws. LAMP COVER he LAMP 1 LAMP 2 7 Connect AC Power Cord to a projector and turn projector on. 8 Reset Lamp Replacement Counter. (Refer to section "Lamp Counter Reset" on page 41.) NOTE : Do not reset LAMP REPLACEMENT COUNTER when lamp is not replaced. SCREWS Make sure which number of lamp needs to be replaced on Lamp Status Display. Figure shows case of replacing LAMP 2. CAUTION : DO NOT OPERATE A PROJECTOR WHILE ANY OF LAMPS IS REMOVED. IT MAY RESULT IN MALFUNCTIONS, FIRE HAZARD, OR OTHER ACCIDENTS. NOTES ON LAMP REPLACEMENT To maintain quality of picture (better balance of color and brightness in entire screen), we recommend replacing all 2 lamps at a time. ORDER REPLACEMENT LAMP Replacement Lamp can be ordered through your dealer. When ordering Projection Lamp, give following information to dealer. • Model No. of your projector : PLC-EF30 • Replacement Lamp Type No. : POA-LMP39 (Service Parts No. 610 292 4848) 45