Sanyo PDG-DHT100L Instruction Manual, PDG-DHT100L - Page 15
Remote Control Battery Installation, Remote Control Receivers and Operating Range, Wired Remote
View all Sanyo PDG-DHT100L manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Part Names and Functions Remote Control Battery Installation 1 Open the battery compartment lid. 2 Install new batteries into the compartment. 3 Replace the compartment lid. Pull up the lid and remove it. Two AA size batteries For correct polarity (+ and -), be sure battery terminals are in contact with pins in the compartment. To ensure safe operation, please observe the following precautions : L Use two (2) AA or LR6 type alkaline batteries. L Always replace batteries in sets. L Do not use a new battery with a used battery. L Avoid contact with water or liquid. L Do not expose the remote control to moisture or heat. L Do not drop the remote control. L If the battery has leaked on the remote control, carefully wipe the case clean and install new batteries. L Risk of an explosion if battery is replaced by an incorrect type. L Dispose of used batteries according to the instructions or your local disposal rule or guidelines. Remote Control Receivers and Operating Range Point the remote control toward the projector (to Infrared Remote Receivers) when pressing the buttons. Maximum operating range for the remote control is about 16.4' (5 m) and 60 degrees from the front, rear or top of the projector. Infrared Remote Receivers are provided in the front and back and on the top of the projector. You can conveniently use these receivers. (pp.10, 56) 16.4' (5 m) Note: •When hanging the projector from the ceiling, select the Infrared Remote Receiver which is located farther away from the fluorescent light. (p.56) •When using the projector in the horizontal position without hanging from the ceiling, it is recommended to deactivate the top Infrared Remote Receiver to avoid the effects of the fluorescent light. (p.56) 16.4' (5 m) Wired Remote Control The remote control can be used as a wired remote control. Wired remote control helps you use the remote control outside of the operating range (16.4'/ 5 m). Connect the remote control and the projector with the remote control cable (sold separately). Connected with the remote control cable, the remote control does not emit wireless signal. 15