Sanyo PDG-DSU30 Owner's Manual - Page 16
Powering Off the Projector, If you wish to turn the projector back on, you must wait
UPC - 086483076596
View all Sanyo PDG-DSU30 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
Installation Powering Off the Projector 1. Press the "ON/STAND-BY" to turn off the projector lamp, you will see a message as below on the on-screen display. 2. Press the "ON/STAND-BY" again to confirm. 3. The cooling fan continues to operate for about 120 seconds for cooling cycle and the POWER LED will flash blue. When the light stop flashing and turn red, the projector has entered standby mode. If you wish to turn the projector back on, you must wait until the projector has completed the cooling cycle and has entered standby mode. Once in standby mode, simply press "ON/STAND-BY" to restart the projector. 4. Disconnect the power cable from the electrical outlet and the projector. 5. Do not turn on the projector immediately following a power off procedure. 15 English English