Sanyo PLC-HF10000L RS232 Basic - Page 16

PLC-HF10000L Basic Serial Command Functional Specifications 7.3 Status Read Command COMMAND "CR0" [CR] Detail Get the projector status Acceptable "%1" [CR] Response "00" = Power ON "80" = Standby "40" = Countdown in process "20" = Cooling Down in process "10" = Power Failure "28" = Cooling Down due to Abnormal Temperature in process "24" = Power Management Cooling Down in process %1 "04" = Power Management status "21" = Cooling Down in process after Off due to lamp failure "81" = Standby after Cooling Down due to lamp failure "88" = Standby after Cooling Down due to Abnormal Temperature "2C" = Cooling Down in process after Power Off due to Shutter management "8C" = Standby after Cooling Down due to Shutter management Unacceptable "?" [CR] Details for Response "00" [CR] Status: Power ON Normal image is on screen. "80" [CR] Status: Standby When the status is Standby, Status Read Commands are always accepted, but Functional Execution Commands are not accepted except POWER ON Command. "40" [CR] Status: Countdown in process When "Display" in Setting menu is set to ON, execution of Power ON operation brings into Countdown status. When "Display" in Setting menu is set to OFF, the status jumps to Power ON without Countdown operation. "20" [CR] Status: Cooling Down in process Execution of POWER OFF Command ("C01" [CR]) in power on status brings into Cooling Down status. This status automatically moves to Standby when the lamp is turned off and the fan spin finishes after about 90 seconds (the time of spinning fan depends on models). During this time, Functional Execution Commands are not accepted. 16/23