Sanyo PLC-XF71 Owners Manual - Page 67
The image is Top/Bottom, The image is Left/Right
UPC - 086483072451
View all Sanyo PLC-XF71 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 67 highlights
Appendix appears on the screen - The end of lamp life is approaching. Replace the lamp with a new one promptly. (See page 55) -The filter is out of scroll. Replace the filter cartridge with a new one promptly. (See pages 57-58) appears on the screen The image is out of focus. - Adjust the focus of the projector. - Check Projection Lens to see if it needs cleaning. ✔Note: Moving the projector from a cool temperature location to a warm temperature location may result in moisture condensation on Projection Lens. In such cases, leave the projector OFF and wait until condensation evaporates. - Projecting from excessive slant angle to the screen may cause keystone distortion and partial imperfect focus. The image is not bright enough. -Check if "Contrast" or "Brightness" are adjusted properly. (See page 45) -Check if "Image level" is selected properly. (See pages 38, 42) -Check the Lamp control function. ( See "SETTING" section on page 51) - Check the Lamp 1/2 replace indicators. If it lights, the end of lamp life is approaching. Replace the lamp with a new one promptly. (See page 61) -The image is darker when 1 lamp mode is selected, compared with 2 lamp mode. Check the lamp mode at SETTING section on page 51. The color is strange. The image is Left/Right reversed. The image is Top/Bottom reversed. The image is distorted or runs off. -Check the Input signal, color system, video system, or computer system mode. - Check the Ceiling / Rear function. (See pages 40, 44.) - Check the Ceiling function. (See pages 40, 44.) -Check "PC Adjust" menu or " Screen" menu and adjust them. Auto PC adjustment function does not work. -Check the Input signal. Auto PC Adjustment function cannot work when 480p, 575p, 720p, 480i, 575i, 1035i, or 1080i is selected or when the digital signal is input into DVI terminal. (See page 35) Some displays are not seen during the operation. - Check the Display function (see page 48). The setting does not remain after turning off power. -Make sure you selected "Store" after adjusting settings. Some settings cannot be stored if not registered with "Store". Power management function does not work. Image disappears automatically. Capture function does not work. Some menus cannot be selected. -Power management function cannot work while "Freeze" function is running or the shutter is closed. - Check the power management function in the Setting. The power management is set to "On" at the factory. -Check the connection to see if there is signal. -Each of the Video Input and Computer Input has a limit on selectable menus. 67