Sanyo PLC-XR70N Owners Manual - Page 13

CONNECTING THE PROJECTOR COMPUTER IN Terminal : HDB15-PIN Connect the display output terminal of the computer to the projector with the VGA Cable (supplied). When connecting the Macintosh computer the MAC/VGA Adapter is required. Pin Configuration 5432 1 10 9 8 7 6 15 14 13 12 11 1 Red Input 9 Non Connect 2 Green Input 10 Ground (Vert.sync.) 3 Blue Input 11 Sense 0 4 Sense 2 12 Sense 1 5 Ground (Horiz.sync.) 13 Horiz. sync. 6 Ground (Red) 14 Vert. sync. 7 Ground (Green) 15 Reserved 8 Ground (Blue) CONTROL PORT Terminal : MULTI-POLE 12-PIN When controlling the computer with the projector's Wireless Remote Control Unit, connect control port (PS/2, Serial or ADB port) on your computer to this terminal. (Three types of cables are supplied.) Pin Configuration 21 6 54 3 10 9 8 7 12 11 NOTE : The R X D port (5th pin on the Serial Port is provided on Control Port 1 only. If your control the projector by computer you must connect Control Port 1 connector. PS/2 1 ----2 CLK 3 DATA 4 ----5 ----6 ----7 ----8 ----9 GND 10 ----11 ----12 ----- Serial T X D R X D ----- READY ----- GND ADB ----- ADB GND VIDEO IN VIDEO / Y Connect the Composite Video output, or the Y signal output from the Component Output Video equipment (like DVD player) to this terminal. C / Cb Connect the C component or Cb component signal output from the Component Output Video equipment to this terminal. Cr Connect the Cr component signal output from Component Output Video equipment to this terminal. BNC Connect the Composite Video output from the BNC terminal to this terminal. When connecting to this terminal, do not connect any input source to the VIDEO terminal. AUDIO R / L Connect the Audio output to this terminal. When the audio output of the audio equipment is stereo, be sure to connect the right and left channels to the respective right and left jacks. And when the audio input of the audio equipment is monaural, connect it to the left jack. CAUTION When connecting the peripheral equipment to the projector, please observe the following precautions: l Be sure that the each equipment is turned off. l Connect the cable securely to the respective terminal. l When removing the cable, never pull the cord. Hold the plug of the cable and remove it. l When operating the peripheral equipment, turn off the other equipment that is not used. 13