Sanyo PLC-XW56 Owners Manual - Page 46

Power management, turned on if the input signal is

Get Sanyo PLC-XW56 - XGA LCD Projector PDF manuals and user guides
UPC - 086483069246
View all Sanyo PLC-XW56 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 46 highlights

Setting Power management For reducing power consumption as well as maintaining the lamp life, the Power management function turns off the projection lamp when the projector is not used for a certain period. When the input signal is interrupted and no button is pressed for more than 30 seconds, the timer display with "No signal" appears. The countdown starts to turn off the lamp. Select one of the operations: Ready When the lamp has been fully cooled down, the POWER indicator changes to green blinking. In this condition, the projection lamp is turned on if the input signal is reconnected or any button on the top control or remote control is pressed. Shut down . . . . . When the lamp has been fully cooled down, the power is turned off. Off Power management function is off. Then set the countdown timer with the Point ◄► buttons. Power management Time left before Lamp is off. Press the SELECT button at Power management and this box appears. Choose one of three settings with the Point◄ ►buttons, and go to the timer with the Point ▲▼ buttons and set time with the Point ◄►buttons. Note: Factory default is "Ready: 5 min." 46

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
Setting
46
Power management
For reducing power consumption as well as
maintaining the lamp life, the Power management
function turns off the projection lamp when the
projector is not used for a certain period.
When the input signal is interrupted and no button is
pressed for more than 30 seconds, the timer display
with "No signal" appears.
The countdown starts to turn
off the lamp.
Select one of the operations:
Ready
........
When the lamp has been fully
cooled down, the POWER indicator
changes to green blinking.
In
this condition, the projection lamp
is
turned on if the input signal is
reconnected or any button on the
top control or remote control is
pressed.
Shut down
....
When the lamp has been fully
cooled down, the power is turned
off.
Off
..........
Power management function is off.
Then set the countdown timer with the Point
◄►
buttons.
Time left before Lamp is off.
Press the SELECT button
at Power management
and this box appears.
Choose one of three
settings with the Point◄
►buttons, and go to the
timer with the Point
▲▼
buttons and set time with
the Point
◄►
buttons.
Power management
Note:
Factory default is “Ready: 5 min.”