Schwinn 120 Upright Bike 2010 model Owner's Manual - Page 18
Contact Customer Care for further
View all Schwinn 120 Upright Bike 2010 model manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
Console displays "E2" error code Check data cable integrity Check data cable connections/orientation Console Electronics No speed/RPM reading, Console displays Check data cable integrity "E3" error code Check data cable connections/orientation Check magnet position (requires shroud removal) Check RPM Sensor (requires shroud removal) Console shuts off (enters sleep mode) while in use Check data cable integrity Check data cable connections/orientation Reset Machine (if equipped with reset button) Check magnet position (Technician onlyrequires shroud removal) Check RPM Sensor Fan (if equipped) will not turn on or will not turn off Check data cable integrity Check data cable connections/orientation Unit rocks/does not sit level Reset Machine (if equipped with reset button) Check leveler adjustment Check surface under unit All wires in cable should be intact. If any are cut or crimped, replace cable. Insure cable is connected securely and oriented properly. Small latch on connector should line up and snap into place. If tests reveal no other issues, Console should be replaced. All wires in cable should be intact. If any are cut or crimped, replace cable. Insure cable is connected securely and oriented properly. Small latch on connector should line up and snap into place. Magnet should be in place on flywheel. If no magnet is present, replace the flywheel or the entire base unit (if unable to replace flywheel). RPM sensor should be aligned with magnet and connected to data cable. Realign sensor if necessary. Replace if there is any damage to the sensor or the connecting wire. All wires in the cable should be intact. If any are cut or crimped, replace cable. Insure cable is connected securely and oriented properly. Small latch on connector should line up and snap into place. Unplug unit from electrical outlet for 3 minutes. Reconnect to outlet. After the Console powers up, press "reset". Magnet should be in place on flywheel. If no magnet is present, replace flywheel or entire base unit. Contact Customer Care for further assistance. All wires in cable should be intact. If any are cut or crimped, replace cable. Insure cable is connected securely and oriented properly. Small latch on connector should line up and snap into place. Unplug unit from electrical outlet for 3 minutes. Reconnect to outlet. After Console powers up, press "reset". Leveling feet may be turned in or out to level bike. Adjustment may not be able to compensate for extremely uneven surfaces. Move bike to level area. 18