Seagate ST4000VM000 Video 3.5 HDD Product Manual (formerly Pipeline HD) - Page 15
Power specifications, 2.8.1 Power consumption, Power dissipation 2-disk values shown - test
View all Seagate ST4000VM000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
www.seagate.com Drive Specifications 2.8 Power specifications The drive receives DC power (+5V or +12V) through a native SATA power connector. (Refer to Figure 3 ). 2.8.1 Power consumption Power requirements for the drives are listed in Table 2 on page 15. Typical power measurements are based on an average of drives tested, under nominal conditions, using 5.0V and 12.0V input voltage at 25°C ambient temperature. • Spinup power Spinup power is measured from the time of power-on to the time that the drive spindle reaches operating speed. • Read/write power and current Read/write power is measured with the heads on track, based on a 16-sector write followed by a 32-ms delay, then a 16-sector read followed by a 32-ms delay. • Operating power and current (CE profile) Operating power is measured by simulating a typical PVR operating environment, using a 50% write, 50% read algorithm. • Idle mode power Idle mode power is measured with the drive up to speed, with servo electronics active and with the heads in a random track location. • Standby mode During Standby mode, the drive accepts commands, but the drive is not spinning, and the servo and read/ write electronics are in power-down mode. Table 2 DC power requirements for 2TB models Power dissipation (2-disk values shown) Avg (watts 25°C) Avg 5V typ amps Avg 12V typ amps Spinup - - 2.0 Idle* † 3.7418 0.221 0.219 Operating 5.05 0.302 0.295 Standby 0.819 0.15 0.005 Sleep 0.819 0.15 0.005 *During periods of drive idle, some offline activity may occur according to the S.M.A.R.T. specification, which may increase acoustic and power to operational levels. †5W IDLE, Standby and Sleep,with DIPLM enabled Table 3 DC power requirements for 1TB models Power dissipation (1-disk values shown) Spinup Idle* † Operating Standby Sleep Avg (watts 25°C) Avg 5V typ amps Avg 12V typ amps - - 2.0 2.502 0.152 0.145 3.676 0.385 0.145 0.819 0.15 0.005 0.819 0.15 0.005 *During periods of drive idle, some offline activity may occur according to the S.M.A.R.T. specification, which may increase acoustic and power to operational levels. Measurement was taken in Idle 1 mode. †5W IDLE, Standby and Sleep,with DIPLM enabled Video 3.5 HDD Product Manual, Rev. H 15