Sennheiser RS 130 Instructions for Use - Page 19
Turning the acoustic signals beeps on and off
View all Sennheiser RS 130 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
ENGLISH Turning the acoustic signals (beeps) on and off The acoustic signals of the headphones can be turned on or off as follows: y Turn the headphones on. y Press the TUNE button for 5 seconds. y Turn the headphones off. y If the acoustic signals are turned on, the headphones produce a sequence of beeps at turn-off. If no beeps are produced, the acoustic signals are now turned off. If problems occur... y Check if all jack plugs are connected correctly. y Make sure that the batteries are charged. y Check if the batteries are inserted correctly and that the polarity is correct. y Check if the headphones and sound source are turned on and that the volume of the headphnes and sound source is sufficient. y Move closer to the transmitter. y Choose a different channel on the transmitter. y Press the TUNE button again. y Reset the system: Remove the rechargeable batteries from the headphones and - at the same time - interrupt the power supply of the transmitter for at least 30 seconds. y Some electronic devices (e.g. televisions) can cause interference, which can be eliminated by increasing the distance between the transmitter and the interference source. y Try to operate the transmitter with a different sound source. Should the problem persist, please contact your authorized dealer for assistance. 17