Sharp DK-AP8P DK-AP8P Operation Manual - Page 11

Remote control - test

Get Sharp DK-AP8P PDF manuals and user guides
UPC - 074000369528
View all Sharp DK-AP8P manuals
Add to My Manuals
Save this manual to your list of manuals

Page 11 highlights

Remote control ■ Batteries installation This product contains a CR Coin Lithium Battery which contains Perchlorate Material - special handling may apply. California residents, see www.dtsc.ca.gov/hazardouswaste/perchlorate/. 1 While pushing the locking tab toward the center of the remote control, slide out the battery holder. Back of remote control Locking tab 2 Remove the old batteries from the battery holder, insert two new batteries and then slide the battery holder back into the remote control. Battery holder DK-AP8P Notes concerning use: ● Replace the batteries if the operating distance is reduced or if the operation becomes erratic. Purchase 2X "CR 2032", coin lithium battery. ● Periodically clean the transmitter on the remote control and the sensor on the unit with a soft cloth. ● Exposing the sensor on the unit to strong light may interfere with operation. Change the lighting or the direction of the unit if this occurs. ● Keep the remote control away from moisture, heat, shock, vibrations and any conductive materials to avoid malfunction. ■ Test of the remote control Point the remote control directly at the remote sensor on the unit. The remote control can be used within the range shown below: Remote sensor Preparation for Use Positive (+) side up Polarity (+) symbol Battery type Locking tab Precautions for battery use: ● Remove the batteries if the unit will not be used for a long period of time. This will prevent potential damage due to battery leakage. Caution: ● Do not use rechargeable batteries (nickel-cadmium battery, etc.). ● Danger of explosion if battery is incorrectly replaced. ● Replace only with the same or equivalent type. ● Batteries (battery pack or batteries installed) shall not be exposed to excessive heat such as sunshine, fire or the like. ● Installing the battery incorrectly may cause the unit to malfunction. ON/STAND-BY ESOUND SKIP ON/STAND-BY CUE/ REVIEW 8" - 20' 15˚ 15˚ (0.2 m - 6 m) MENU TV DISPLAY ENTER CURSOR PLAY MODE SHUFFLE ESOUND VOLUME 11

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
11
DK-AP8P
Preparation for Use
Remote control
■
Batteries installation
This product contains a CR Coin Lithium Battery which contains
Perchlorate Material – special handling may apply. California
residents, see www
.dtsc.ca.go
v/hazardous
w
aste/perchlor
ate/
.
Precautions for battery use:
●
Remove the batteries if the unit will not be used for a long
period of time. This will prevent potential damage due to
battery leakage.
Caution:
●
Do not use rechargeable batteries (nickel-cadmium battery,
etc.).
●
Danger of explosion if battery is incorrectly replaced.
●
Replace only with the same or equivalent type.
●
Batteries (battery pack or batteries installed) shall not be
exposed to excessive heat such as sunshine, fire or the like.
●
Installing the battery incorrectly may cause the unit to
malfunction.
Notes concerning use:
●
Replace the batteries if the operating distance is reduced or
if the operation becomes erratic. Purchase 2X “CR 2032”,
coin lithium battery.
●
Periodically clean the transmitter on the remote control and
the sensor on the unit with a soft cloth.
●
Exposing the sensor on the unit to strong light may interfere
with operation. Change the lighting or the direction of the unit
if this occurs.
●
Keep the remote control away from moisture, heat, shock,
vibrations and
any conductive materials to avoid malfunction.
■
Test of the remote control
Point the remote control directly at the remote sensor on the
unit
.
The remote control can be used within the range shown
below:
1
While pushing the locking tab toward the center of the
remote control, slide out the battery holder.
2
Remove the old batteries from the battery holder, insert
two new batteries and then slide the battery holder back
into the remote control.
Back of remote control
Locking tab
Battery holder
Polarity (+) symbol
Battery type
Locking tab
Positive (+)
side up
ON/STAND-BY
E
SOUND
R
E
V
I
E
W
C
U
R
S
O
R
V
O
L
U
M
E
C
U
E
/
S
K
I
P
P
L
A
Y
M
O
D
E
ON/STAND-BY
ENTER
E
SOUND
MENU
TV DISPLAY
SHUFFLE
15˚
15˚
Remote sensor
8” - 20’
(0.2 m - 6 m)