Sharp DK-KP80P Operation Manual - Page 8

Listening to the iPod, iPhone or iPad (continued) Note: When navigating the iPod, iPhone or iPad menu with remote control, do not operate any of the buttons on the iPod or iPhone unit. The volume level is adjusted by pressing the VOL (+ or -) button on the main unit or the remote control. Adjusting the volume on the iPod, iPhone or iPad units give no effect. iPod, iPhone and iPad operations: The operations described below depend on the generation iPod, iPhone and iPad you are using. System on operation: When the main unit is powered on, the iPod, iPhone or iPad units will automatically power on when docked or connected in the unit. System off (stand-by operation): When the main unit is turned to stand-by mode, the docked iPod, iPhone or connected iPad unit will automatically turn to stand-by mode. ■ To disconnect iPod, iPhone or iPad Simply remove the iPod or iPhone from the docking station or iPad connector from USB terminal. It is safe to do so even during playback. Caution: ● Unplug all accessories for the iPod or iPhone before inserting it into the docking station. ● Stop button ( ) at main unit is invalid during iPod function. ■ Various iPod, iPhone and iPad functions Function Main unit Dock/USB Play Pause Track up/ down Fast forward/ reverse Repeat ____ Shuffle Menu ____ Enter ____ Remote control Dock USB Operation Press in the pause mode. Press in the playback mode. Press in the playback or pause mode. If you press the button in the pause mode, press the / button to start the desired track. Press and hold down in the playback mode. Release the button to resume playback. Press to toggle repeat mode. Press and hold to toggle shuffle mode. Press to view the iPod menu during iPod function. Press to confirm the selection. Cursor ____ Up/Down Press to select the iPod menu. Listening to a CD or MP3/WMA disc POWER ■ Disc playback 1 Press the POWER ON/STAND-BY button to turn the power on. 2 Press the CD button on the remote control or FUNCTION button repeatedly on the main unit to select CD function. 3 Press the OPEN/CLOSE button to open the disc compartment. 4 Place the disc in the disc compartment, label side front. 5 Press the OPEN/CLOSE button to close the disc compartment. 6 Press the / (CD / ) button to start playback. After the last track is played, the unit will stop automatically. Caution: ● Do not place two discs in the disc compartment. ● Do not play discs of special shapes (heart, octagon, etc). It may cause malfunctions. ● Do not push the disc compartment while it is moving. ● If the power fails while the compartment is open, wait until the power is restored. ● If TV or radio interference occurs during CD operation, move the unit away from the TV or radio. ● Be sure to place 8 cm (3") disc in the middle of the disc compartment. ● Due to the structure of the disc information, it takes longer to read an MP3/WMA disc than a normal CD (approximately 20 to 90 seconds). Notes for CD or MP3/WMA disc: ● When the end of the last track is reached during fast forward, "END" will appear on the display and CD operation will be paused. When the beginning of the first track is reached during fast reverse, the unit will enter the playback mode (only for CD). ● Rewritable multi-session discs with unfinished writing, can still be played. ■ Direct track search By using the Numeric buttons, the desired tracks on the current disc can be played. Use the Numeric buttons on the remote control to select the desired track while playing the selected disc. ● The Numeric buttons allow you to select up to number 9. ● When selecting number 10 or higher, use the "10+" button. E-7