Sharp KB-4425L KB-3425LS , KB-3425LK , KB-3425LW Operation Manual - Page 44

Cleaning and care Oven racks Clean with soap and water, rinse and polish dry. To remove stubborn soil, use an abrasive cleanser or steel wool. After cleaning, rinse the racks with clean water and dry with a clean cloth. Note: • If the racks become hard to slide, apply a small amount of cooking oil to a paper towel and wipe on the edges of the oven racks. • Do not leave in oven during self-cleaning cycle. Broiler Pan, Grid and roast/broil rack Remove from oven at end of roasting or broiling. Drain away fats and accumulated juices. Sprinkle the grid with detergent and cover with wet paper towels or wet dish cloth. Allow to cool. Wash in hot soapy water and scrub any remaining food particles with a soap filled pad or plastic scouring pad. Rinse and polish dry with a soft cloth. The broiler pan, grid and roast/broil rack can be washed in the dishwasher. Note: • Do not leave in oven during self cleaning cycle. Oven light replacement CAUTION Be sure the oven is unplugged and all parts are COOL before replacing the oven lightbulb. Do not turn the oven light on during the self-cleaning cycle. The high temperature will reduce lamp life. The interior oven light will turn on automatically when the oven door is opened. The oven light may be turned on when the door is closed by using the oven light switch located on the control panel. The bulb is covered with a glass shield held in place by a wire holder. This glass shield must be in place whenever the oven is in use. To replace the light bulb 1 Turn the power off at the main source. 2 Wear a glove with leather palm for protection against possible broken glass. 3 Replace bulb with a 40 watt appliance bulb only. 4 Press wire holder to one side to release glass shield. Replace glass shield. 44