Sharp MX-4101N MX-4100N MX-4101N MX-5001N Safety Guide - Page 6

INSTALLATION REQUIREMENTS Improper installation may damage this product. Please note the following during initial installation and whenever the machine is moved. 1. The machine should be installed near an accessible power outlet for easy connection. 2. Be sure to connect the power cord only to a power outlet that meets the specified voltage and current requirements. Also make certain the outlet is properly grounded. • For the power supply requirements, see the name plate in the lower left corner of the left side of the machine. Connect the machine to a power outlet which is not used for other electric appliances. If a lighting fixture is connected to the same outlet, the light may flicker. 3. Do not install the machine in areas that are: • damp, humid, or very dusty • exposed to direct sunlight • poorly ventilated • subject to extreme temperature or humidity changes, e.g., near an air conditioner or heater. 4. Be sure to allow the required space around the machine for servicing and proper ventilation. 5. The machine includes a built-in hard drive. Do not subject the machine to shock or vibration. In particular, never move the machine while the power is on. 11-13/16" (30cm) 11-13/16" (30cm) 17-23/32" (45cm) A small amount of ozone is produced within the printer during operation. The emission level is insufficient to cause any health hazard. NOTE: The present recommended long term exposure limit for ozone is 0.1 ppm (0.2 mg/m3) calculated as an 8 hr. time-weighted average concentration. However, since the small amount that is emitted may have an objectionable odor, it is advisable to place the copier in a ventilated area. 4