Sharp MX-4101N MX-4100N MX-4101N MX-5001N Software Setup Guide - Page 32

4 Select [SC2 TCP/IP Port] and then click the [New Port] button. In Windows 98/Me, select [Other], [SC2 TCP/IP Port], and then click the [OK] button. 5 Create the new port. • The "SC2 TCP/IP Port" is added when the printer driver is installed using a "Standard installation", or a "Custom installation" with "LPR Direct Print (Specify Address/Auto Search)" selected. • If the printer driver is installed using a "Custom installation" with "IPP" selected, the [SC-Print2005 Port] is added. If you need to change the printer port when the machine is connected to an intranet or a wide area network (WAN) using the IPP function, select [SC-Print2005 Port], click the [New Port] button (the [OK] button in Windows 98/Me), and follow the on-screen instructions to create the port again. (1) (2) (3) (4) (1) Enter the machine's IP address. ☞ Checking the IP address of the machine (page 7) (2) Make sure that [LPR] is selected. (3) Make sure that [lp] is entered. (4) Click the [OK] button. 6 Click the [Close] button in the screen of step 4. In Windows 98/Me, this step is not required. Go to the next step. 7 Make sure the created printer port is selected in the printer properties window and then click the [Apply] button. X When using a port created with "Standard TCP/IP Port" When using a port created using "Standard TCP/IP Port" in Windows 2000/XP/Server 2003/Vista/Server 2008, in the screen that appears after you click the [Configure Port] button in the screen of step 3, make sure the [SNMP Status Enabled] checkbox is not selected ( ). If the [SNMP Status Enabled] checkbox is selected ( ), it may not be possible to print correctly. 30