Sharp MX-950 MX-M850 MX-M950 MX-M1100 Operation Manual Suite - Page 617

Other Settings Copy Exposure Adjustment This is used to adjust the exposure level when [Auto] is used for the copy exposure. Select separate settings for the document glass and for the automatic document feeder. Rotation Copy Setting When the original and paper are placed in different orientations, this function automatically rotates the image 90 degrees to enable correct copying on the paper. • Image rotation can only take place when automatic paper selection or automatic ratio selection is enabled. • The Rotation Copy setting must be enabled when copying a 5-1/2" x 8-1/2" (A5) size original on 5-1/2" x 8-1/2"R (A5R) paper. Add or Change Extra Preset Ratios Two enlargement preset ratios (101% to 400%) and two reduction preset ratios (25% to 99%) can be added. An added preset ratio can also be changed. Preset ratios other than added preset ratios cannot be changed. Setting a Maximum Number of Copies This is used to set the maximum number that can be entered for the number of copies (number of continuous copies). Any number from 1 to 9999 can be specified. Erase Width Adjustment This is used to set the default erase width for erase copy. Specify a value from 0" (0 mm) to 1" (20 mm) in increments of 1/8" (1 mm) for both edge erase and center erase. The default settings configured here are applied to copy mode, document filing mode, and image send mode. Card Shot Settings This is used to set the default original size for the card shot function. Both the X (horizontal) and Y (vertical) dimensions of the original can be set from 1" (25 mm) to 8-1/2" (210 mm) in increments of 1/8" (1 mm). Fit to Page Enable this setting to have the [Fit to Page] key always appear in the card shot screen. The default settings configured here are applied to copy mode and document filing mode. The default settings are not applied to "Card Shot" of image send mode. Automatic Saddle Stitch (When a saddle stitch finisher or saddle unit is installed.) This is used to have saddle stitch stapling take place automatically when the pamphlet copy function is used. Initial Margin Shift Setting This is used to set the default margin shift amount. Specify a value from 0" (0 mm) to 1" (20 mm) in increments of 1/8" (1 mm) for both the front and reverse sides. 47