Sharp MX-M450N Administration Guide - Page 18

COPY SETTINGS This section explains the administrator settings that are used for copy mode. Copy settings "Copy settings" consists of the following settings: Initial status settings Exposure adjustment Rotation copy setting Add or change extra preset ratios 600dpi x 600dpi scanning mode for document feeder Quick scan from document glass Initial margin shift setting Erase width adjustment*1 Card shot settings*1 Setting a maximum number of copies Disabling deletion of job programs Disabling of bypass-tray in duplex copy Disabling of auto paper selection *1 Default settings selected with these settings apply to all functions of the machine (not just the copy function). Initial status settings The copy settings revert to the default settings when the power switch is turned on, when the [CA] key is pressed, or when the auto clear time elapses. This setting is used to change the default settings, or return changed default settings to the initial factory default settings. Defaults for the following copy settings can be changed: Paper tray/Exposure tray/Copy ratio/2-sided copy/Out put (auto, sort, staple sort, group, output tray) NOTE If this setting is used to change the default setting for the duplex function to other than "one-sided" "one-sided" and the automatic document feeder fails or is disabled*, the setting will revert to "one-sided" "one-sided". * DISABLING OF DOCUMENT FEEDER (page 11) DISABLING OF DUPLEX (page 11) Exposure adjustment This setting is used to adjust the exposure level when "Auto" is used for the copy exposure. The factory setting is "5". "1" indicates lighter density and "9" indicates darker density on the touch panel. Rotation copy setting This setting is used to have the image of an original automatically rotated when the orientation of the original does not match the orientation of the copy paper. (Rotation copy will function only if the auto paper select or auto image mode has been selected.) NOTE To copy an A5 or 5-1/2" x 8-1/2" size original onto A5R or 5-1/2" x 8-1/2"R paper, this setting must be enabled. Add or change extra preset ratios When using AB sizes, there are normally five preset enlargement ratios and five preset reduction ratios. When using inch sizes, there are normally four preset enlargement ratios and four preset reduction ratios. This setting allows you to add two more preset enlargement ratios and two more preset reduction ratios. This setting also allows you to change a preset ratio. NOTE Only an added preset ratio can be changed. 600dpi x 600dpi scanning mode for document feeder Use this setting to change the original scanning resolution of the automatic document feeder from 600 x 300 dpi to 600 x 600 dpi. If this mode is set, the copy quality for fine characters and fine lines will be improved but the original scanning speed will be slower. NOTE If you prefer a quicker scanning speed over higher resolution, do not enable this setting. Quick scan from document glass Use this setting to change the original scanning resolution on the document glass from 600 x 600dpi to 600 x 300 dpi. When this setting is enabled, the first copy time will be shorter, however, copy images will be slightly coarser. NOTE If you prefer a higher quality copy image over a shorter first copy time, do not enable this setting. 16