Sharp R-201FW Service Manual - Page 7

installing this appliance, observe all applicable codes and ordinances. A short power-supply cord is provided to reduce risks of becoming entangled in or tripping over a longer cord. Where a two-pronged wall-receptacle is encountered, it is the personal responsibility and obligation of the customer to contact a qualified electrician and have it replaced with a properly grounded three-pronged wall receptacle or have a grounding adapter properly grounded and polarized. If the extension cord must be used, it should be a 3-wire, 15 amp. or higher rated cord. Do not drape over a countertop or table where it can be pulled on by children or tripped over accidentally. Grounded Receptacle Box 3-Pronged Plug Grounding Pin 3-Pronged Receptacle R-201FK/W R-203FW R-205FW R-206FW CAUTION: DO NOT UNDER ANY CIRCUMSTANCES CUT OR REMOVE THE ROUND GROUNDING PRONG FROM THIS PLUG. 1 Door open button Push to open door. OVEN DIAGRAM 5 9 10 2 Oven door with see-through window 3 Safety door latches The oven will not operate unless the door is 13 8 securely closed. 4 Door hinges 4 12 5 Door seals and sealing surfaces 6 Turntable motor shaft 7 Removable turntable support 7 1 Carefully place the turntable support in the center of the oven floor. 8 Removable turntable Place the turntable securely on the turntable support. The turntable will rotate clockwise or counterclockwise. Only remove for cleaning. 9 Ventilation openings (Rear) 32 6 11 10 Oven light It will light when oven is operating. 11 Waveguide cover: DO NOT REMOVE. 12 Auto-Touch control panel 13 Time display: 99 minutes, 99 seconds TOUCH CONTROL PANEL R-201FW R-203FW R-205FW R-206FW NOTE: R-201FK Some one-touch cooking features such as "MINUTE PLUS" are disabled after three minutes when the oven is not in use. These features are automatically enabled when the door is opened and closed or the STOP/ CLEAR pad is pressed. 5