Sharp R1874 R-1870 , R- 1871 , R-1872 , R-1874 Installation Instructions - Page 7

4. Thread the power supply cord through the hole made in the bottom of the top cabinet. 5. Hang the oven on the lower edge of the mounting plate. Rotate the unit upward. See Figure 22. Take care that the power cord is able to clear the edge of the hole as the oven is rotated upward. (In the case of a non-recessed bottom in the top cabinet, the hole for the cord may need to be enlarged.) Remove the carton portions. 6. Tighten the two unit mounting screws located in the grease filter openings. See Figure 23. 7. Install grease filters by fitting into the opening. Push back and up into place. See Figure 24. 8. Use the two Top Cabinet Screws (D) and two Flat Washers (E), supplied in the INSTALLATION HARDWARE, to attach the unit to the top cabinet. See Figure 25. 9. Make a bundle of the power supply cord and place it inside the cabinet. Hang at these locations (A) Figure 22 Unit mounting screw Figure 23 Grease filter Figure 24 Figure 25 Grommet (for metal cabinet only) (D) (E) 7