Sharp VL-NZ100U VLNZ100U|VLNZ150U Operation Manual - Page 24
Preparation
View all Sharp VL-NZ100U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
Preparation PPrerpearpataionration Attaching and Removing the Battery Pack Attaching Power switch Removing 1 Make sure that the Power switch is set to OFF. 2 Rotate the monitor section of the camcorder (1), then press the battery release (2). Slide the battery pack in the direction of the arrow and take it out (3). 1 Make sure that the Power switch is set to OFF. 2 Align the = mark on the side of the battery pack with the = mark on the camcorder (1), and slide the battery pack in the direction of the arrow completely until it locks into place (2). Battery release Cautions: • BEFORE REMOVING THE BATTERY PACK, ALWAYS STOP RECORDING OR PLAYBACK AND TURN THE POWER OFF. Removing the battery pack while shooting or during playback may damage the tape by causing it to wrap around the video head drum or destroy the card, rendering it unreadable and unwritable. • Remove the battery pack from the camcorder if you will not use the camcorder for a long period of time. • Make sure that the battery pack is firmly attached during operation. If it is not, the battery pack may come off or camcorder operation may fall because of the poor contact pressure. • To prevent damage to the battery pack when removing, be sure to firmly hold the battery pack while pressing the release. • Use only SHARP model BT-L225 or BT-L445 battery packs with this camcorder. Use of other batteries may create a risk of fire or explosion. 9