Sharp XE-A202 Service Manual - Page 3
Display - error 3 2
UPC - 074000048270
View all Sharp XE-A202 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
The mode switch has these settings: OFF: This mode locks all register operations. (AC power turns off.) No change occurs to register data. OP X/Z: To take individual clerk X or Z reports, and to take flash reports. It can be used to toggle receipt state "ON" and "OFF" by pressing he [RCPT/PO] key. REG: For entering sales. PGM: To program various items. VOID: Enters into the void mode. This mode allows correction after finalizing a transaction. MGR: For manager's entries. The manager can use this mode for an override entry. X1/Z1: To take the X/Z report for various daily totals. X2/Z2: To take the X/Z report for periodic (weekly or monthly) consolidation. 5. DISPLAY 1) OPERATOR DISPLAY Display device: LED numeric display Number of line: 1 line Number of positions: 10 positions numeric display Color of display: Yellow / Green Character form: 7 segment + DP Character size: Numeric 14.2 (H) x 7.9 (W) mm Layout: 0.1.2.3.4.5.6.7.8.9. 2) CUSTOMER DISPLAY Display device: LED Number of line: 1 line Number of positions: 7 positions Color of display: Yellow / Green Style: Pop up type Character form: 7 segment + Dp Character size: 14.2mm (H) x 7.9mm (W) Layout: 3.4.5.6.7.8.9. Operator display PLU/SUB DEPT REPEAT Customer display (Pop-up type) Clerk code RCPT OFF DC SHIFT NUMBER Amount: Appears in the far-right eight (max.) positions. When the amount is negative, the minus symbol "-" appears before the amount. Number of repeats for repetitive registrations: The number of repeats is displayed, starting at "2" and incremental with each repeat. When you have registered ten times, the display will show "0." (2 3 3 ..... 9 3 0 3 1 3 2 ... ) Receipt function status: The indicator "_" appears in the RCPT OFF position when the receipt function is in the OFF status. Time: Appears in the far-right six positions (hour-minute - "A" or hour-minute - "P") in the OP X/Z, REG, or MGR mode. "A" is displayed in the morning (AM), and "P" in the afternoon (PM). In the REG or MGR mode, press the [#/TM/SBTL] key to display the time. sMachine state symbols : Appears during programming. : Appears when an error is detected. : Appears when the subtotal is displayed or when the amount tendered is smaller than the sales amount. : Appears when the [CONV] key is pressed to calculate a subtotal in foreign currency. : Appears when a transaction is finalized by pressing the [CA/AT/ NS], [CHK] or [CH] key. : Appears when the change due amount is displayed. : May appear in the far-left three positions at the timing of key entry when the electronic journal (EJ) memory is full. (Depending on programming.) : Appears when the voltage of the installed batteries is under the required level. You must replace with new ones within two days. : Appears when the batteries are not installed, or the installed batteries are dead. You must replace with new ones immediately. : May appear right below the eighth and ninth places at the timing of finalization of a transaction when the electronic journal (EJ) memory is nearly full. Also appears right below the tenth place when power save mode is effective. : Appears when the print roller arm is not locked. : Appears when the paper is not set or out. XE-A202U SPECIFICATIONS - 2 -