Sharp XV-Z17000 XV-Z17000 Operation Manual - Page 76
operation or interference. If this should happen, unplug the unit and plug it in again after more than - vision
View all Sharp XV-Z17000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 76 highlights
Troubleshooting (Continued) Problem 3D images are not displayed. 3D Images flicker when watching in a room. Ghosting (a double image) occurs without the image appearing in 3D. The projected image is dark. The 3D Glasses turn off automatically. Pressing the power button on the 3D Glasses does not cause the LED light to light. Check • Switch to 3D mode. • Is "3D Auto Change" set to "No"? Press 3D ON/OFF to switch to 3D mode. • If "3D Auto Change" is set to "Yes" but no 3D images are displayed, check the display format of the content being viewed. Some 3D image signals may not be recognized as 3D images automatically. Press 3D MENU to select the appropriate display format for the 3D image. • The 3D Glasses are not turned on. • The 3D Glasses are set to 2D mode. • The 3D Glasses operate by receiving the infrared signal reflected onto the screen. Do not place anything between the screen and the infrared receiver on the 3D Glasses. • Images may appear to flicker when fluorescent light or ambient light enters your vision. -Turn off the lights. -Block any ambient light. • Use "Invert" to change the setting. • A signal that does not support 3D is being received. Check whether a signal that supports 3D is being received. • If the projector is connected to a computer for 3D image playback, check that a stereoscopically-enabled application is being used. - Use the applicable software - Configure your 3D application at the correct 3D format, resolution and refresh rate. To support 3D, your 3D application must be configured to run at the correct settings for this projector. • If there is strong ambient light, block the light. High intensity lighting can interfere with communication between the 3D Glasses and the screen, resulting in some flicker. • A picture simultaneously projected from more than two projectors may not appear 3D. Use only one projector at a time. • When a 3D image is projected, the screen may appear darker than normal. • Is there an obstacle between the 3D Glasses and the screen, or is something covering the infrared receiver on the 3D Glasses? The 3D Glasses turn off automatically after 3 minutes if no signal is received. Do not place anything between the screen and the infrared receiver on the 3D Glasses. • The battery in the 3D Glasses is exhausted. If the LED light does not light after pressing the power button for more than one second, the battery is exhausted. Replace the battery. Page 53, 54, 55 55 55, 56 52 52 - - 55 71 - - - - - 51 This unit is equipped with a microprocessor. Its performance could be adversely affected by incorrect operation or interference. If this should happen, unplug the unit and plug it in again after more than 5 minutes. -74