Singer The SINGER 160 Instruction Manual 5 - Page 18

' .. . . ... ANGIN THE NEEDLE Turn the power switch to "OFF" before changing the needles. Hexagon wrench key Do not use any needle which is bent or blunt. I.Turn the handwheel toward you until the needles are fully raised. 2.Open the front cover and lower the presser foot. 3. Using the hexagon wrench key from the accessory box, loosen the needle clamp screws and remove the needles. Upper left screw for left needle and lower right screw for right needle. 4.Insert the new needle with the flat side to the back into the needle clamp, making sure it is inserted as far up as possible. Tighten the needle clamp screw firmly. Needle (Use HA*1) When the needles are set correctly, the left needle is slightly higher than the right one. If needles are not correctly inserted, skipped stitches will result. This machine is equipped with needle systems H.A *1 ( Needle are household type). Flat side to the back Machine front EPLACING THE BULB Turn the power switch to "OFF" before replacing the bulb. 1.Take the hole cap off by needle. 2.Loosen the screw until it is taken apart. 3.Pull the lamp cover off from the low part. O 4.Push and twist and then remove the old bulb. 0 5.Insert the new bulb and twist to its position. Important: This machine is designed to ues 12 voltage 6 watt bulb. The bulb is available from your local dealer. -17-