Sony BDP-S280 Operating Instructions - Page 21
Specifications, Playback does not start from the resume - remote codes
View all Sony BDP-S280 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
Additional Information Playback does not start from the resume point where you last stopped playing. , The resume point may be cleared from memory depending on the disc when - you open the disc tray. - you disconnect the USB device. - you play other content. - you turn off the player. The disc tray does not open and "LOCKED" or "TLK ON" appears on the front panel display. , When "LOCKED" appears, the player is locked. To cancel the Child Lock, hold down N on the player until "UNLOCK" appears on the front panel display (page 6). , When "TLK ON" appears, contact your Sony dealer or local authorized Sony service facility. The disc tray does not open and you cannot remove the disc even after you press Z. , Try the following: 1Turn the player off, and disconnect the AC power cord. 2Reconnect the AC power cord while pressing down Z on the player. 3Keep pressing down Z on the player until the tray opens. 4Remove the disc. 5When "OPEN" appears on the front panel display, hold down [/1 on the player for more than 10 seconds until the player turns off. "Exxxx" or "TEM ERR" appears on the front panel display. , When "Exxxx" appears, contact your nearest Sony dealer or local authorized Sony service facility and give the error code. , When "TEM ERR" appears, place the player in a location with adequate ventilation to prevent heat build-up in the player. The player does not respond to any button. , Moisture has condensed inside the player (page 3). , Hold down [/1 on the player for more than 10 seconds until the player enters standby mode. If the player still does not respond to any button, disconnect then reconnect the AC power cord. Specifications System Laser: Semiconductor laser Inputs and outputs (Jack name: Jack type/Output level/Load impedance) LINE OUT R-AUDIO-L: Phono jack/2 Vrms/10 kilohms DIGITAL OUT (COAXIAL): Phono jack/0.5 Vp-p/75 ohms HDMI OUT: HDMI 19-pin standard connector COMPONENT VIDEO OUT (Y, PB, PR): Phono jack/Y: 1.0 Vp-p/ PB, PR: 0.7 Vp-p/75 ohms LINE OUT VIDEO: Phono jack/1.0 Vp-p/75 ohms LAN (100): 100BASE-TX Terminal USB: USB jack Type A (For connecting a USB memory, memory card reader, digital still camera, and digital video camera) General Power requirements: 120V AC, 60Hz Power consumption: 16 W Dimensions (approx.): 430 mm × 199 mm × 36 mm (17 in. × 7 4/5 in. × 1 7/16 in.) (width/depth/height) incl. projecting parts Mass (approx.): 1.6 kg (3 lb 9 oz) Operating temperature: 5 ºC to 35 ºC (41 °F to 95 °F) Operating humidity: 25 % to 80 % Supplied accessories • Audio/video cable (phono plug ×3) (1) • Remote commander (remote) (1) • Size AA (R6) batteries (2) Specifications and design are subject to change without notice. ,continued 21