Sony CRX100E User Guide - Page 9

AC Power Inlet The Spressa USB uses a 100 to 240V, 50Ð60 Hz, 1.2 Amp Maximum auto switching power supply. This will allow the unit to be attached to either 110 volt or 220 volt circuits. USB Cable and Connectors Connects to open USB port of PC or Macintosh Connects to driveÕs interface connector The Universal Serial Bus does not require any terminators or the adjustment of any settings of your computer. USB ports and cables are identified by the USB symbol. To remove the USB port connector: Ñ Grasp the port connector and pull to remove. To attach the device connector of the USB cable: Ñ Keep the I/O symbol up, push the buttons on the side of the connector and attach to the driveÕs interface connector. When the connection is secure, release the buttons. One of the advantages of the USB connector is that each connector can be inserted in only one way. The top of the connector has the USB symbol. To attach the port connector of the USB cable: Ñ Keep the USB symbol up and insert into the USB port. The USB port connector and the USB have interlocking tongue elements which hold the contact points together. 10 CRX100E/X - Spressa USB User's Guide The shield which protects the contact points of the USB connector is slightly larger at the top. The tongue of the USB connector on the cable will fit in the groove of the USB connector on the device. The buttons on the side of the connector control clamps which assure a secure connection. To remove the USB device connector: Ñ Push the buttons on the side of the device connector together and pull to remove. CRX100E/X - Spressa USB User's Guide 11