Sony DAV FX900W Operating Instructions - Page 25
Installing the Speakers and the IR transmitter on a Wall, Installing the IR transmitter on a wall
UPC - 027242686908
View all Sony DAV FX900W manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
Getting Started - ADVANCED - Installing the Speakers and the IR transmitter on a Wall 1 Prepare screws (not supplied) that are suitable for the hole on the back of each speaker. See the illustrations below. 4 mm (5/32 inch) 30 mm (1 3/16 inch) 4.6 mm (3/16 inch) 10 mm (13/32 inch) Hole on the back of the speaker 2 Fasten the screws to the wall. For the front and surround speakers 330 mm (13 inch) Note • Use screws that are suitable for the wall material and strength. As a plaster board wall is especially fragile, attach the screws securely to a beam and fasten them to the wall. Install the speakers on a vertical and flat wall where reinforcement is applied. • Contact a screw shop or installer regarding the wall material or screws to be used. • Sony is not responsible for accident or damage caused by improper installation, insufficient wall strength or improper screw installation, natural calamity, etc. Installing the IR transmitter on a wall You can hang the IR transmitter on a wall when: - there is an obstruction between the IR transmitter and IR receiver of the surround speaker (L). - people often pass between the IR transmitter and IR receiver of the surround speaker (L). When hanging both the IR transmitter and surround speaker (L), adjust the position of the IR transmitter after deciding the position of the surround speaker (L). 1 Rotate the stand of the IR transmitter. IR transmitter 8 to 10 mm (11/32 to 13/32 inch) 3 Hang the speakers on the screws. 4.6 mm (3/16 inch) 10 mm (13/32 inch) Stand 2 Install 2 commercially available screws in the wall so that it protrudes 4 mm (3/16 inch). Install the screws 30 mm (1 3/16 inch) apart. continued 25US