Sony DHG-B45CV Installation Guide - Page 18

Other Information Changing the Digital Home Receiver's RF Output Channel If you connected the Digital Home Receiver to your TV or VCR using an RF connection (as described on pages 9 and 10), you need to set the RF output channel of the Digital Home Receiver to match the RF channel (channel 3 or 4) of the cable service provided in your area. The Digital Home Receiver is shipped with its RF output channel set to channel 3. To set the RF output channel of the Digital Home Receiver 1 Using the buttons on the front panel, first press the STANDBY 1 button to turn off the Digital Home Receiver, which puts the unit in standby mode. 2 To set the Digital Home Receiver to channel 3 or 4: To Use RF Channel 3 Channel 4 Press These Front Panel Buttons Sequentially F (cursor up), g (cursor right), f (cursor down) F (cursor up), g (cursor right), F (cursor up) 3 Do one of the following: ❑ If you connected the Digital Home Receiver to your TV (as described on page 9), tune your TV to channel 3 to see cable channels. ❑ If you connected the Digital Home Receiver to your VCR (as described on page 10), set your VCR's RF channel switch (usually on the rear panel) to channel 3 to see cable channels. 12